Fribosa is no longer active.
Your clamping devices still need service.

Over the years, wear changes the parallelism and squareness of clamping devices – the result is inaccurate workpieces. Send us your vise or clamping fixture: we measure both values and restore the factory accuracy. You receive a free cost estimate in advance as to whether overhaul is worthwhile or whether a replacement is more economical.

We repair defective clamping jaws, spindles or housings even without original documentation – based on photos, the type designation on the device or a short phone call. Where a repair no longer makes sense, we say so openly and point out alternatives.

We supply individual components – clamping jaws, spindles, T-nuts and other replacement parts – from our own range or manufacture them to size if the original part is no longer available. A drawing, a photo with dimensions or the original part for measurement is sufficient.

If a repair is no longer economical, we offer the precision tool maker vise EHS as a direct replacement from our own production – in steel or rust-resistant design, made in Germany. Details and ordering below.